Downloading mBlock, installing drivers and connecting

Download Arduino Llc (www.arduino.cc) Usb Devices Drivers

This issue might occur due to some of the driver conflict. I suggest you to uninstall the driver from device manager, download the latest USB driver for Arduino Uno form the manufacturer’s website and install it. Follow the below steps: Step 1: Uninstall the USB driver for Arduino Uno. 1) Press Windows key + x and select Device Manager. Solution that I found: Arduino Uno: - Will mostly work out of the box. If not recognized, install the drivers from Microsoft Windows 10 update site. Arduino Nano: - Windows 10 built-in installers are not working. Download the Zipped version of Arduino IDE (meant for non-admin installation) from Arduino web site.

1. Install the Arduino Windows Drivers 1. ทำการ Plug the Arduino Board ลงบนเครื่อง PC. ทำการ Plug the Arduino board ลงบนเครื่อง PC. Windows จะพยายาม install drivers แต่สุดท้ายก็จะไม่สำเร็จ. Start the Windows Device Manager.
2. NI Device Drivers provides popular NI instrument drivers you can use to control NI and third-party hardware. NI Device Drivers is a bundle that features most NI instrument drivers, including NI-DAQmx, NI-VISA, NI-SCOPE, and NI-SWITCH.

Once you have your robot built and running, we encourage you to dive into the world of programming with mBlock. The following is an introduction in how to get setup.

1. Install and open the software.
2. Get the Arduino drivers. For PC users, go to the Connect menu in mBlock:
   For Mac users, download the driver. Unfortunately, the latest update for the Mac OSX introduced an issue with this driver. Find out about the solution to this issue.
3. Connect your robot to your computer via USB cable, turn your robot on, and open mBlock. Go to Connect-> Serial Port -> (port ID). (TIP: If you don’t know the port ID you are connected to, make a note of the available ports, disconnect your robot, and see which port disappears.) Once you have successfully connected, the title bar will say you are connected and the red dot in the “Robots” Scripts will turn green:
   NOTE: To upgrade firmware, to reset the default program and to upload a program onto the robot board, you MUST be connected via USB.
4. Next, make sure you have the appropriate board selected in the Board menu:
   • Starter / Ultimate – Orion
   • mBot – mCore
   • mBot Ranger – Auriga
   • Ultimate 2.0 – Mega Pi

   Here, I am using mBot, so the mCore board is selected:
   

Now you are ready to start programming.

Download Arduino Llc (www.arduino.cc) Usb Devices Driver Download

Download Arduino Llc (www.arduino.cc) Usb Devices Driver Updater

Construct Your Dreams!